logo

Crowdly

Browser

Add to Chrome

ENGG1310 Electricity and electronics [Section 2D, 2024]

Looking for ENGG1310 Electricity and electronics [Section 2D, 2024] test answers and solutions? Browse our comprehensive collection of verified answers for ENGG1310 Electricity and electronics [Section 2D, 2024] at moodle.hku.hk.

Get instant access to accurate answers and detailed explanations for your course questions. Our community-driven platform helps students succeed!

What categories do the following waveforms belong to?

0%
0%
0%
0%
0%
View this question

In figure (a) and (b), what are the equivalent inductance LAB , the equivalent capacitance CAB and the equivalent resistance RAB of the circuits, respectively?

0%
0%
0%
0%
0%
View this question

Given the following parameters of an EV battery: battery capacity E = 150kWh, the final state of charge (SOC) SOC1 =70%, charging power Pch = 60kW, discharging power Pdis = 30kW, charging time tch = 1 hours, discharging time tdis = 1.8 hours, charging efficiency ηch = 90%, and discharging efficiency ηdis = 90%, what is the initial SOC (SOC0) of the battery? (The related formulas are as follows)

0%
0%
0%
0%
100%
View this question

Consider a three-phase, four-wire Y-connected circuit. If the line voltage of the power source is 440V and the loads are Ra = 44Ω, Rb = 22Ω, and Rc = 11Ω, respectively. Please calculate the line voltage and the three phases' total power P.

0%
0%
0%
0%
0%
View this question

A voltage waveform is shown below, please find its RMS voltage value. Choose the value that is closest to the answer.

0%
100%
0%
0%
0%
View this question

Which of the following is not the characteristic of wind turbines?

0%
0%
0%
0%
0%
View this question

A thermal power plant has the following data:

Thermal Unit No.

Capacity (MW)

Forced outage rate

1

2000

28%

2

1900

20%

3

1600

8%

Please give the loss of load probability (LOLP) under the following two scenarios:

Scenario No.

Demand (MW)

Scenario A

5000

Scenario B

1500

0%
0%
0%
0%
0%
View this question

The following figure shows a transformer.

Given that AC voltage source is 𝑉𝑆1 = 3000 V, DC voltage source is 𝑉𝑆2 = 2000 V, and 𝑅1 = 𝑅2 = 300Ω.

Calculate the peak value of 𝐼𝑆 .

0%
0%
0%
100%
0%
View this question

For the Boolean expressions:

the output Y is always 1 when

0%
0%
0%
0%
100%
View this question

Which of the following logic gate will produce the same results as the following truth table with C and D as inputs, and Z as the output ?

100%
0%
0%
0%
0%
View this question

Want instant access to all verified answers on moodle.hku.hk?

Get Unlimited Answers To Exam Questions - Install Crowdly Extension Now!

Browser

Add to Chrome