Problem 2 (vi): What is the force of member 3 need to be transferred into the gusset plate? (kN)

Problem 2 (v): What is the block shear strength of the gusset plate near member 2? (kN)

Problem 2 (viii): What is the required length of the weld on the side with the leg for member 3, L_5. (mm)

Problem 2 (vii):  What is the total length of weld required, L_w, on member 3 to transfer the force from Part (VI)? (on one side)

Problem 2 (i):  From the joint equilibrium, what is the factored axial force, N₂*? (kN)

Problem 1 (iv): What is the minimum fillet weld size, t_wmin? (mm)

Problem 2a (vii b): What is the minimum distance provided between the hole centre and the inside face of the angle in the long leg? (mm)

Problem 2a (vii a): What is the minimum distance provided between the hole centre and the inside face of the angle in the short leg? (mm)

Problem 2a (v): What is the actual bolt hole centre spacing in the direction of applied force? (mm)

Note: This question is different from the one in the handout. Ignore the word "minimum".

Problem 2a (i): What is the minimum required distance from the centre of the hole to the edge in any direction based on NZS 3404 clause 9.6.2? (mm)