Crowdly
Додати до Chrome
Course 36865
Шукаєте відповіді та рішення тестів для Course 36865? Перегляньте нашу велику колекцію перевірених відповідей для Course 36865 в moodle.taltech.ee.
Отримайте миттєвий доступ до точних відповідей та детальних пояснень для питань вашого курсу. Наша платформа, створена спільнотою, допомагає студентам досягати успіху!
Spot welding cycle stages are
By means of spot welding
Which turning operation and which workpiece surface is possible to machine with the shown cutting tool?
Calculate feed rate for the cutter shown below if the feed rate per tooth is 0.3 (mm) and the rotational speed N is 2359 (rev/min).
F=n·f·N,
where n - is amount of cutter's teeth.
Round up the answer to 1 decimal place.
Determine the required cutting time T (s) for the workpiece made of steel (cutting speed V=400 m/min) external turning. Machined outer surface diameter d=295.8 mm and cutting length is 966 mm. The feed during turning is s=2.9 (mm/rev) and the depth of cutting t=1.0 (mm), see figure below.
To calculate cutting time T (s) use following equation:T=l/(s·N),
where N - spindle rotational speed, rev/s; l - cutting length, mm.
Answer round up to two decimal places.
What is the type of cutting tool shown in figure below?
Calculate the deformation rate Vkr, if the steel has the following chemical composition:
C = 0.5 %S = 0,030 %Si = 1.5 %Mn = 0,73 %Mo = 0,24 %P = 0,026 %Ni = 1,42 %
Provide the answer with an accuracy of two decimal places.
What is the type of cutting tool shown in figure below?
Which turning operation and which surface of workpiece is possible to machine with the shown in the figure cutting tool?
Calculate Hot Cracking Susceptibility(HCS) for a steel with following chemical composition:
C = 0.4Si = 3.9Mn = 0,84P = 0,035S = 0,012Cr = 1.3Mo = 0,32Ni = 0,99Cu = 0,11V = 0,040
Provide the answer with 1 decimal place accuracy.