The part on the left has its default reference planes going through the middle of the part. However, when it was dropped into the assembly, it's planes didn't line up with the planes of the assembly, as shown in the image. How can you best edit the position of the part so that its planes line up with the planes of the assembly?

Question

Accepted Answer

Float the part and manually add mates between the planes of the assembly and the planes of the part.

Answer

You cannot edit the position of the part.

Answer

Float the part and align the planes manually. When the planes visually match up, fix the part once again.

Answer

Delete the part and drop it into the assembly again. Repeat this process until the planes line up.

Crowdly

The part on the left has its default reference planes going through the middle o...

Хочете миттєвий доступ до всіх перевірених відповідей на elearning.aua.am?