The model in the left image has a rectangular cut-out. To create the cut, you need to use the dimensions shown in the image. Based on the dimensions given and the design intent of the part, which of the following methods should you use to create the cut-out? Pick the best answer.

Question

Accepted Answer

Use Offset Entities to offset the edges of the face 0.50 units, and then create the cut-out.

Answer

Use Convert Entities to copy the edge of the face onto a new sketch, and then create the cut-out.

Answer

Use the rectangle tool to create the geometry, then dimension each line 0.50 units from the edges, and then create the cut-out.

Answer

Use the line tool to create the geometry, then dimension each line 0.50 units from the edge, and then create the cut-out.

Crowdly

The model in the left image has a rectangular cut-out. To create the cut, you ne...

Хочете миттєвий доступ до всіх перевірених відповідей на elearning.aua.am?