If a part (cylindrical hole) with actual dimension of 59.998 mm is inspected with a brand new limit gauge designed with the tolerances as shown below, what would be the outcome of the inspection?

Question

Answer

The part will pass, because both sides of the gauge will fit in.

Answer

The part will pass the inspection

Answer

None of the suggested

Answer

The part will fail the inspection, because both sides will not fit in.

Answer

The part will fail the inspection, because the GO side will not fit in.

Crowdly

If a part (cylindrical hole) with actual dimension of 59.998 mm is inspected wit...

Хочете миттєвий доступ до всіх перевірених відповідей на moodle.port.ac.uk?