Crowdly

Add to Chrome

Universities
lms.bstsrhberlin.com
Project Lab (including SMSCP Level 1)_Elective A/B

Project Lab (including SMSCP Level 1)_Elective A/B

Looking for Project Lab (including SMSCP Level 1)_Elective A/B test answers and solutions? Browse our comprehensive collection of verified answers for Project Lab (including SMSCP Level 1)_Elective A/B at lms.bstsrhberlin.com.

Get instant access to accurate answers and detailed explanations for your course questions. Our community-driven platform helps students succeed!

In the crankshaft position sensor, as shown below, the induced voltage

across the coil is caused by ..

a tab passing through

the magnetic field.

100%

rotation of the steel

disk

none of these.

acceleration of the

steel disk’s rotational speed.

current in the coil.

View this question

What will be the data stored in the destination address for Source A XOR Source B?

Source A - 0000 0000 0001 0110

Source B - 0000 0000 0010 1101

0000 0000 0000 1111

An induction motor has synchronous speed (Ns) of 1200 RPM and runs at a frequency of 40 c/s. Calculate the number of poles of the induction motor.

p=5

p=2

An induction motor has no poles

p=4

View this question

A gear has 18 teeth (Z) and a diametral pitch (Pd) of 8. What is its pitch diameter(d)?

2.25 inch

50%

4 inch

2.75 inch

3 inch

50%

View this question

The start address

(Identifier) "I" is used for which of the following?

Inputs

50%

Set

Memory

Reset

Outputs

50%

View this question

What statement about the detecting the advanced or retracted position of the piston rod, shown below are correct?

The contact reeds are opened by a magnetic field

An electrostatic field causes the reeds to close.

The field of the magnet causes the reeds to close, allowing the current to flow.

Reed switches operate without contact and external mechanical actuating force.

View this question

To measure electrical.....

resistance, the ohmmeter must be placed in series with the component

current, the ammeter must be in line with the current path.

25%

voltage, you must disconnect a component leador a wire before you connect the voltmeter.

75%

none of these

View this question

By reading the multimeters in the electrical circuit shown below, determine the type of failure in the circuit and which component failed

R4 and R5 are open

There is a solder splash short circuit between Point A & Point B

R1 is shorted

R3 is shorted

View this question

You are a PLC Engineer troubleshooting a control circuit issue. The problem: Motor M1 is not running. According to the current system status, the claw is confirmed to be closed, but motor M1 does not start.

Refer to the control diagram and the function chart below. Based on your observations and the available information, which of the following troubleshooting statements are correct?