Crowdly
Add to Chrome
2025SU ELC-119-02BL NEC Calculations
Looking for 2025SU ELC-119-02BL NEC Calculations test answers and solutions? Browse our comprehensive collection of verified answers for 2025SU ELC-119-02BL NEC Calculations at moodle.pittcc.edu.
Get instant access to accurate answers and detailed explanations for your course questions. Our community-driven platform helps students succeed!
The full load current for a 100 HP, 3-phase, 460 volt synchronous-type motor operating at 80% power factor would be:
0%
0%
0%
0%
View this question
Motors marked with a 1.10 service factor or a 30 degree C temperature rise are to have their minimum overcurrent protection device set at:
0%
0%
0%
0%
View this question
Branch circuit conductors for motors should be computed at:
❌
✅
❌
❌
View this question
This pull box is to enclose conductors larger than #6 AWG. What is the minimum size pull box that can be used for this installation?
0%
0%
0%
100%
View this question
The minimum length for this pull box enclosing conductors larger than #6 AWG shal be:
100%
0%
0%
0%
View this question
The 4" conduits of this pull box are to enclose the same conductors What is the minimum distance ("C") that shall be maintained between these raceway entries?
0%
0%
0%
100%
View this question
What is the correction factor for an Aluminum conductor type SIS when installed in a 140-degree F ambient room?
❌
0%
100%
0%
View this question
When will a conductor with type XHHW insulation have an operating temperature of 90 Degrees C?I. when used in dry or damp locationsII. when used in wet locations
0%
0%
0%
0%
View this question
The maximum number of #10 THHN conductors that can be installed in a 1 inch EMT conduit is:
0%
0%
0%
0%
View this question
The total Cross-sectional area of the conductors installed in an 18 inch conduit nipple should not exceed ______________ of the total cross-sectional area of the conduit nipple.
0%
0%
0%
0%
View this question